It's hard to unplug the battery!Updated 2 years ago

It is a tight fit - but you don't have to worry too much about pulling the wires loose.  We have not seen this happen to the XT60 connector. As of this writing, it has only been reported twice involving the connectors seen below as JST-XHR-4P & 5P that attached to the charger in all the thousands of batteries sold.

Leaving the LiPo battery plugged into the main drive unit when not in use is not recommended. The battery may continue to drain - and if the voltage drops below the minimum voltage this will permanently damage the battery. This would not be covered under warranty, so to protect your investment ALWAYS disconnect the battery plug from the drive when not in use.

Always charge the battery inside a fireproof container such as a battery charging bag

IMPORTANT: charge to "FUL" before use to assure proper balance of all cells inside the battery. 

If the battery is used before it reaches FUL - this will permanently damage the battery causing it to stop taking and/or holding a charge.

Note: you can stop charging before it reaches full and continue charging later - as long as you don't USE it until it has been fully charged. 

Disclaimer

The advice given above is general in nature and you are responsible for the safety of your batteries. SwiftPaws is not responsible for any direct, indirect, special, or consequential damages and personal injuries, including that to life, and health, resulting from the customer’s application and use of batteries sold by SwiftPaws.com.