SwiftPaws Support logo
SwiftPaws Support logo

All collections

Recalibrating the Remote Controller

TO CALIBRATE THE REMOTE CONTROLLER:

1) Press and hold the on/off button for 15 seconds.

a) Keep holding for the full 15 seconds - the LED lights will turn on and off show green and red and vibrate - just keep holding ...

b) After 15 seconds it will vibrate one long time and show a steady red light for a few seconds and then go off.

 

2) Then press and release the button again to turn the remote on.

a) it will vibrate 3 short times and begin flashing green.

 

3) As it flashes green - push the white trigger wheel all the way up until it vibrates once.

a) The LED continues to flash green.

 

4) Then push the wheel all the way down until it vibrates once.

a) The LED continues to flash green.

 

5) Lastly - when you move the trigger wheel once more in either direction the LED light will turn to steady green. 

It should now be communicating with the drive. 

- If it will not operate the drive and/or if the LED does not turn to steady green after moving the trigger wheel a third time (step 5) please reach out to [email protected] and send a video showing what is happening. 

Was this article helpful?
Yes
No