Using the HotRC Battery charger

The HotRC charger has a display window that shows the present charge of the battery when it is plugged in. Use the charger away from flammables and monitor it while in use.

  • Plug the charger in first to make sure it is getting power. The readout will show 000 (it may take a few moments to display)
  • Then connect the battery - the display will show the battery's current voltage
  • Charge to the maximum capacity of your battery (the capacity does decline over time)
  • Remove the battery from the charger once it's fully charged
  • The last stage of the charging process balances the voltage between the internal cells in the battery pack

See this article:  Why recharge the battery for each use?

NOTE: the charger will get very hot during a certain point in the charging cycle, this is normal. What is not normal is if the charger is too hot to hold, or if the case is warped. In either case, unplug the charger and do not use it. It should be replaced.

About:

weight:135g
Size: 98*60*26MM
Max charge current: 3000ma
Battery type: 4s 3s lipo
Balanced current: 300ma/cell
Max charge power:40W
Charge stop voltage:4.2V ±0.02V
Shell material: ABS+pc fireproof material
display accuracy:±0.05V




CAUTION: The battery should always be allowed to come to room-temperature before charging. Charging a hot or cold battery might delay charging or damage the battery. For best results, charge the battery at temperatures between 50º and 80ºF (10º-30ºC).

Disclaimer
The advice given above is general in nature and you are responsible for the safety of your batteries. SwiftPaws is not responsible for any direct, indirect, special, or consequential damages and personal injuries, including that to life, and health, resulting from the customer’s application and use of batteries sold by SwiftPaws.com.

Aug 29, 2024

Contact Us

Not finding what you're looking for? Contact Us Directly