Remote Control Features - ♾️Universal Remote

The ♾️Universal remote controller syncs with the main drive and must remain withing 10-15 feet of the drive to maintain this connection. It ships already calibrated. It uses a replaceable CR123A battery which lasts 2 or more years. Do not use rechargeable batteries.

TURN IT ON

• By pressing the power button once
• You'll feel three slight vibrations and the LED light will blink green about once per second.
• Turn on the app controlled device (Chase drive and the Original and Plus drives manufactured after June 27th)
• The LED will blink slightly faster and slightly brighter when it pairs with the device.
• Move the trigger wheel in either direction and the LED turns steady green
• This starts the 90 second play session timer
• And it now powers the drive - moving the line/flag in variable speeds and both directions (controlled using the trigger)
• At 80 seconds into the play session the remote will vibrate and the LED will turn red - signaling the end of the play session is 10 seconds away.

TURN IT OFF

• Press the and hold the power button until the remote vibrates twice - and the LED turns red
• It will power down
• OR - do nothing and the remote will turn itself off after 90 second play session times out.

THE AUTOMATIC SHUTDOWN SAFETY FEATURE

• At 80 seconds into a play session
• The remote controller will vibrate twice and
• The LED light will turn red for 10 seconds
• If you do nothing, the auto-shutdown safety feature engages.
• OR you can bypass the auto shutdown - see next section.

TO BYPASS THE AUTOSHUTDOWN

• Press and hold the power switch within the10 seconds remaining after the 80 second warning
• Hold briefly until the LED light turns from green to red (it only takes a moment).
• The remote will vibrate twice and the light will turn green again - indicating the beginning of another 90 second play session without interruption.
• We do not recommend bypassing the play session
• Instead - allow your pup to catch their breath and get some water and the motor of your drive to cool down before starting another session.

TO ENTER LOW SPEED MODE

• With the remote on, paired, and in play mode
• Press the power button three (3) times to enter slow mode.

TO ENTER LINE WIND-UP MODE

• With the remote on, paired, and in play mode -
• Press the power button five (5) times to enter Wind-Up mode
• OR -
• If already in slow mode -
• Press the power button two (2) more times to enter Wind-Up mode

To stop low speed and return to normal speed:

• Turn off both the drive and remote.
• When you turn them back on you'll be back to normal speed.