About the HotRC Upgraded ChargerUpdated 5 months ago

When charging the Home Original 11.1v battery using the HotRC charger:

• Connect the battery 4 pin connector to the "3 cell" four pin port on the charger
• Lining up the tabs on the connector with the notches in the charger port

It is not possible to connect the battery to the wrong port - just make sure the number of pin holes match the number of pins in the charger port!

• Charge to the maximum capacity before each use - even if you only used it a little bit last time. 
• Note: you may not see the "FUL" indicator - once the voltage stops increasing you can consider the battery charged to the maximum capacity 👍

NOTE: Always send a picture when reaching out for support by emailing [email protected]

CAUTION: The battery should always be allowed to come to room-temperature before charging. Charging a hot or cold battery might delay charging or damage the battery. For best results, charge the battery at temperatures between 50º and 80ºF (10º-30ºC).

Disclaimer

The advice given above is general in nature and you are responsible for the safety of your batteries. SwiftPaws is not responsible for any direct, indirect, special, or consequential damages and personal injuries, including that to life, and health, resulting from the customer’s application and use of batteries sold by SwiftPaws.com.